Part Numbers

Product Codes

QCC-M	Modbus® WAN Output QCC Controller
QCC-B	BACnet® WAN Output QCC Controller

Factory Options

-AO	Two internal Analog Outputs 4-20 mA, includes data logging
-IH	Internal heater for cold environment applications down to -40°C / 40°F
-L	Top mounted strobe, red lens, IP65 rated, 6.1 cm dia x 13 cm H / 2.4 in dia x 5.2 in H)
-SW	Manual shutoff switch for refrigeration applications
-WA	Door mounted, water tight audible alarm, rated 85 dB @ 60.96 cm / 2 ft

Field Options

QCC-OPTION AO	Analog Output board for adding two internal 4-20 mA analog outputs plus data logger to the QCC, install in the field by qualified technician only or send back to factory for installation
CET-BAC-MOD	CETCI BACnet Module for converting QCC-M WAN communication from Modbus® to BACnet®, installed in the field

Compatible Analog (4-20 mA) Transmitters

LPT Series	Single channel analog gas detector for monitoring carbon monoxide, nitrogen dioxide, ammonia, chlorine, ozone or oxygen
LPT-A series	Single channel analog gas detectors for monitoring many different toxic, combustible or refrigerant gases
CXT-A series	Single channel, analog explosion proof gas detectors for monitoring toxic or combustible gases in hazardous-rated areas
CGAS-A-CO2-5%	Single channel analog infrared CO2 gas detector with 0 - 5% vol measurement range NOTE: The QCC is not compatible with CGAS-A-CO2-5K or CGAS-AP-5K

Compatible Digital (Modbus® RS-485) Transmitters

CGAS-D Detector Series	2 channel, digital gas detectors for monitoring many different toxic, combustible or refrigerant gases. NOTE: The QCC is not compatible with CGAS-D-CO2-5K or CGAS-DP-CO2-5K
LPT-P series	3 channel, digital gas detectors for monitoring CO, NO2 and combustible gases
LPT-M series	3 channel, digital gas detectors for monitoring many different toxic, combustible or refrigerant gases

Remote & Peripheral Devices

LNK-AO	Analog Output Peripheral Device that adds four 4-20 mA outputs, Modbus® RS-485 communication
LNK-XT	Network Extender Peripheral Device to extend the Modbus® RS-485 BUS wire length
QCC-RDM	Remote Display for alternate location viewing of gas level readings
RLY-4	Remote Relay that adds four relay outputs, rated 5A @ 240 volts each, Modbus® RS-485 communication
RPS-24VDC	Remote Power Supply to provide power to extend the network of remote and peripheral devices
RSA-24V	Remote LED strobe light with audible, red lens, 8.9 cm / 3.5”, comes with mounting bracket
RSH-24V-A	Remote Horn/Strobe Combo, unmounted, 24 VAC/VDC, rated 99 dB @ 3 m (10 ft) (VAC), 97 dB @ 3 m (10 ft) (VDC), amber lens
RSH-24V-B	Remote Horn/Strobe Combo, unmounted, 24 VAC/VDC, rated 99 dB @ 3 m (10 ft) (VAC), 97 dB @ 3 m (10 ft) (VDC), blue lens
RSH-24V-R	Remote Horn/Strobe Combo, unmounted, 24 VAC/VDC, rated 99 dB @ 3 m (10 ft) (VAC), 97 dB @ 3 m (10 ft) (VDC), red lens